SETflow X-231

SETflow X-231

The SETflowTM LTE-M X231 endpoint is an innovative two-way radio that operates over existing cellular and LoRa networks, providing water utilities with remote meter reading, sensor data, and multiple read and transmit options. With the cellular antenna mounted above the meter lid, the X231 offers excellent signal range in rural areas, or where cellular coverage is limited or obstructed.

 

Connectivity Options

  • Cellular Network
  • WIFI
  • Bluetooth
  • LoRaWAN
  • GPS

SETflow X-231:

Network Provider

The X231 cellular endpoint operates on AT&T and Verizon in the U.S. LoRaWAN is optionally included on endpoints, along with Wifi and Bluetooth.

Network Provider

The X231 cellular endpoint operates on AT&T and Verizon in the U.S. LoRaWAN is optionally included on endpoints, along with Wifi and Bluetooth.

Installation and Setup

SETflowTM X231 endpoints are shipped with the cellular radio powered Off and with the installed Bluetooth radio powered On. Once the endpoint is connected to your water meter, valve, or sensor, the installer will connect to the endpoint using any Bluetooth enabled smartphone running the SETflowTM Field Mobile app.

After successfully logging into the mobile app the installer can activate the cellular/LoRa radio, take pictures of the final installation, enter notes, assign utility premise/location ID, enter initial meter reading, final meter reading if replacing an existing meter, the old and new meter IDs, and immediately confirm cellular signal strength before leaving the site.

ENDPOINT FEATURES

  • The X231 endpoint can be installed in meter pits, attached to walls, or any environment where cellular or LoRa signal is available.
  • The installer can determine cellular availability using the SETflowTM Field mobile app.
  • SETflow Endpoints operate on a D cell battery.
  • The high-density polycarbonate enclosure construction uses a fully encapsulated epoxy resin to ensure the battery and all internal electronics are protected against moisture and vibration.
  • Endpoints can be connected to any encoded output meter using a three-wire connector.
  • Most connectors are supported and can be pre-configured with your connector of choice.
  • If no connector is needed, Endpoints can be shipped with open wire leads for gel-cap or other connection options.

Do you want to know more?

Other Products

X-231

SETflow™

Smart Valve

SETflow™

Enterprise Cloud

SETflow™